[Suspend2-devel] Hang at "Copying Original Kernel Back" after upgrading RAM

[Guan Sin Ong]

I recently upgraded my RAM from 512MB to 1GB and swsusp2 stops working
since then - it hangs at resume at the point of "Copying Original Kernel
Back". 

Attached is the .config. Hardware is an IBM T42, running 2.6.11 kernel on
FC3 using swsusp2 2.1.8.9. Suspend to swap partition of 1.5GB. 

I have tried turning off ACPI with "acpi=off" as suggested, but it did not
help. Also tried with single user mode, same problem too. 

After much trial and error, I took out the 512MB module and it works again.


Any advice will be appreciated. Thanks!

-GS


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: kconfig
Type: application/octet-stream
Size: 44651 bytes
Desc: 2269948813-kconfig
URL: <http://lists.tuxonice.net/pipermail/tuxonice-devel/attachments/20050614/b351d713/attachment.obj>